The new Seneca Z-SG3 is a load cell converter (strain gauge). The measurement carried out with the 4 or 6-wire technique, is available via Modbus RTU serial protocol or via the analog output. The strain gauge can be directly powered by the instrument. The load cell calibration is managed by EASY SETUP software in the factory calibration or sample weight mode.
Z-SG3 includes advanced functions (piece counter, automatic tare reset, threshold alarm, firmware automatically updatable) and flexible measurement management mode (measurements available both in full and floating-point, measurement stabilized through noise filter, configurable resolution). The configuration is via software, while the baud rate and Modbus address are via DIP switch.
Very easy to program via USB and FREE PC software or Android software
Labview Drivers Available !
Check It ! Maybe you need this too ...
